Thatcher CX4 and RV 10 May 31 2023 Build
-
Bill and Walt N drill rivet holes in a piece of sheet metal skin for the RV10 tail section -
Bill covers loose rivets while Walt N sand the edge of the RV10 tail skin -
Bill removes clecos as Walt N drills larger rivet holes on RV10 skin -
Bob F and Bill move the RV10 tail section outside -
Bob F clecos in a bulkhead in the RV10 tail section -
Bob F fits a RV10 tail section bulkhead into place -
Bob F works on a RV10 tail bulkhead -
Bob N cuts a L bracket into supports for the new workbench in Hanger 38 -
Bob N uses the rivet gun while Bob F holds the bucking bar inside the RV10 tail -
Debbie and Glenn work on Cub Weathervanes -
Glenn shows Debbie how to tap a rod hole in the base of a Cub Weathervane -
Len debuts rivet holes in the CX4 horizontal stabilizer -
Lenny works on the CX4 horizontal stabilizer -
Mike and Rich steady the RV10 tail as Bob N uses the rivet gun and Bob F holds the bucking bar -
Mike watches as Wayne measures and Len sets clecos in the CX4 horizontal stabilizer -
Rich and Bob N drill rivet holes in the RV10 tail section -
Rich holds the bucking bar inside the RV10 tail section while Bob N uses the riveting gun -
Scotttt drills rivet holes in RV10 supports -
Walt N holds a piece of RV10 sheet metal while Bill dimples rivet holes -
Wayne and Len measure rivet holes in the CX4 horizontal stabilizer -
Wayne is being reflective -
What did Bob F say to Mike
