Thatcher CX 4 and RV 10 May 24 2023 Build
-
Bob F prepares to drill rovet holes in a RV10 tail part -
Bob F works on a section of the RV10 tail -
Bob N and Walt N discuss what to rivet next -
Bob N rivets inside the RV10 tail section -
Bob N rivets the RV10 tail section -
Bob N sets a rivet in the RV10 tail section -
Debbie tries to squeeze a rivet gun to set a rivet in a Cub Weathervane -
Gene works on a Cub Weathervane while Bob F drills a part for the RV10 -
Jacob and Wayne measure the rivet hole spacing on the CX4 horizontal stabilizer -
Jacob grinds down a metal table bracket to be used in Hanger 38 -
Len trims the sheet metal skin for the CX4 horizontal stabilizer -
Len Wayne and Jacob work on the CX4 horizontal stabilizer -
Looking down the inside of the RV10 tail as Rich sets rivets -
Looking down the inside of the RV10 tail section -
Mike and Bob N steady the RV10 tail as Walt N uses the rivet gun -
Walt N and Rich steady the RV10 tail as Bob N uses the rivet gun -
Walt N Bob N and Rich work on riveting the Rv10 tail section -
Walt N looks on as Rich holds the bucking bar and Bob N uses the rivet gun -
Walt N prepares to rivet a bulkhead on the RV10 tail section -
Wayne smooths the edge of the CX4 horizontal stabilizer skin -
Wayne trims the CX4 horizontal stabilizer sheet metal skin -
Working on the RV10 tail
