Thatcher CX 4 and RV 10 March 8 Build
-
A father and son discussion -
Bill Bob F and Charlie discussing the CX 4 cockpit supports -
Bill cuts out a plate for the CX 4 fuselage supports -
Bill holds a plate as Bob F drills a hole in a CX 4 fuselage support -
Bob F disengages the drill after drilling a bolt hole for a CX 4 fuselage support -
Bob F drills a bolt hole in a CX 4 fuselage support while Charlie takes measurements -
Bob F looks on as Bill works on a Thatcher CX 4 cockpit support -
Bob F looks to place a bolt in a CX 4 bulkhead support -
Bob F smooths a part for the Thatcher CX 4 -
Bob F works on a CX 4 bulkhead -
Bob F works on joining the supports -
Bob N and Mike work on adding supports to a RV 10 horizontal stabilizer -
Bob N polishes a part for the RV 10 -
Cub weathervane jig and sheet metal plates -
Dave and Doug work on a RV 10 horizontal stabilizer -
Dave drills holes in a RV 0 horizontal stabilizer -
Debbie works on Cub weathervanes -
Gene polishes a RV 10 horizontal stabilizer -
Have Harley will ride -
Kurt bends sheet metal over the Cub weathervane jig -
Kurt looks on as Debbie bends a sheet metal part for a Cub weathervane -
Kurt works on a Cub Weathervane while Debbie works on a RV 10 support -
Mike Dave and Bob N work on supporting a RV 10 horizontal stabilizer -
Mike looks on as Kurt works on a Cub weathervane -
Mike places clecos after Dave drills the holes in a RV 10 horizontal stabilizer
