From National Weather Service: A storm cell is forming 20 miles northwest of Oshkosh. There is the potential for 25-30 mph wind gusts & rain. If this cell tracks towards Oshkosh, it could arrive around 4:30 to 4:40 p.m.
Your browser is not compatible with this website. Preferred browsers: Google Chrome, FireFox, or Microsoft Edge
Click here to upgrade to a newer version of Internet Explorer or Microsoft Edge.
Click here to upgrade to a newer version of Internet Explorer or Microsoft Edge.
Cookies are required for this site to operate correctly
EAA Chapter 898
Ocean County, NJ
- Contact Us
- 2022 Holiday Party
- 2023 Winter Leadership School Activities in Oshkosh
- Aerobatic Competition 8-12-22
- Safety Seminars
- Special Events
- Workshop Photos
- Vintage Aircraft Tour 7-5-22
- Event Calendar
- Newsletters
- Young Eagles
- Eagle Flights
- Technical Counselors
- Flight Advisors
- Ray Aviation Scholarship
Thatcher CX4 February 1 2023 Build
-
Making the plan for the night -
2 Bob F cuts an engine support beam -
3 Plans for converting to a tri gear -
4 Charlie and Bob F discuss the front strut placement -
5 Charlie and Bob continue discussing the front strut placement -
6 Doug and Bob F review the front strut placement -
7 Doug and Bob F position the front strut against the firewall -
8 Doug measures to cut a hole in the jig for the front strut -
9 Doug drills a pilot hole for the jig saw -
10 Doug cuts a hole in the jig for the front strut -
11 Walter and Doug look at a control rod -
12 Walter and Rich discuss placement of a control rod bushing -
13 Walter drills a bolt hole for a control rod bushing -
14 Drilling a hole to secure a control rod bushing -
15 Installing a control rod bushing -
16 Walter and Rich mark the placement of another control rod bushing -
17 Walter prepares to use a right angle drill for the installation of a control rod bushing -
18 Horizontal stabilizer installation directions -
19 Walter and Charlie discuss the horizontal stabilizer -
20 Walter reviewing the horizontal stabilizer plans -
21 Walter and Kurt compare horizontal stabilizer parts against the plans -
22 Walter and Kurt work on the horizontal stabilizer -
23 Kurt removes a cleco so Walter can expand a rivet hole -
24 Debbie removes plastic from RV 10 supports -
25 Mike polishes RV 10 while Walter works on the Thatcher horizontal stabilizer
To provide a better user experience, EAA uses cookies. To review EAA's data privacy policy or adjust your privacy settings please visit: Data and Privacy Policy.