Thatcher CX4 November 9 2022 Build
-
Bob F and Doug discuss moving the fuselage -
Bob F drills a rivet hole in a support angle -
Bob F gets ready to move the fuselage -
Bob F looks at a fuselage detail -
Bob F makes a curved cut in a support angle -
Bob F marks a support angle iron -
Bob N fabricates a support -
Charlie Bob F and Bob N review the plans -
Doug and Bob F preparing to take a detailed measurement -
Doug and Gene look on as Charlie and Bob F discuss the support placement -
Doug sets a wooden support to hold the fuselage -
Doug takes a detail measurement of a support angle for fabrication -
Gene and Doug discuss the support placement -
Gene slips by as Doug grinds a support angle -
Power Lever -
Scrap after cutting sheet metal -
Thatcher plans
